Operation Of Remote Control Unit - Kenwood XD-750 Instruction Manual

Operation of remote control unit

1 4
Loading batteries
1 Remove the cover.
Operation
Plug the pow er cord into the mains pow er outlet and press
the (on/ standby) key of the remote control unit to
turn pow er ON. After the pow er has been turned ON, press
the desired key.
To turn pow er off, press the
The system enters the standby mode in w hich only the
time display is lit.
÷ When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
betw een keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries w ith new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
Downloaded from: http://www.usersmanualguide.com/
2 Insert batteries.
÷ Insert tw o R6 (" AA" -size) batteries fol-
low ing the polarity indications.
(on/ standby) key again.
3 Close the cover.
30 °
30 °
M odel: RC-H3R/ H2R
Infrared ray system
XD-7 5 0 / 7 0 0 / 5 5 0 / 5 0 0 (En)
Remote sensor
6 m
Operating range (approx.)