Orx Flight Stabilisation System; Features; Channel Input; Setup - H-KING Vought f4U Corsair Instruction Manual

Table of Contents

ORX flight stabilisation system

• Integrated with a 32bit MCU and a 6 axis digital gyro for ultra fast flight control response

• The ORX stabilization device is tuned specifically to a particular model for the best flying performance.

• Supports PWM, PPM and SBUS. Auto-detect.

• Supports 2 different flight modes (Beginner and Expert)

• PWM input: Here is the channel assignment and shown as follows. Ch 1. Aileron, Ch 2.Elevator, Ch 3

Throttle, Ch 4 Rudder and Ch 5 Flight mode (A 2 position or a 3 position switch should be assigned for

flight mode selection)

• PPM input: Plug the flight mode/SBUS/PPM channel input plug into your receiver which supports PPM

out.

Here is the ch assignment and shown as follow.

1. Aileron, Ch 2. Elevator, Ch 3 Throttle and Ch 4 Rudder. Ch 5 (A 2 position or a 3 position switch for flight.

mode selection)

•SBUS input: Plug the Flight mode/SBUS/PPM channel input plug into a receiver which supports SBUS.

Place your F4U Corsair on level ground. Plug in your battery flight pack and let it sit still, at this moment the plane

is in auto self-calibration mode. The LED light on the stabilization device will keep flashing rapidly for 3-6 secs,

then the light will remain solid. In the mean time the aileron, elevator and rudder control surfaces will move up/

down and left/right 3 times to indicate the self-calibration is successful.

When the self calibration has been carried out the stabilization system is still not in ready mode. Now check to see

if all the control surfaces are in a neutral position. If not, please adjust the push-rod clevises to ensure all the

control surfaces are in neutral position before flight, then cycle the battery power to store this setup.

After all these setup procedure have been completed plug in the battery once again and wait until all the control

surfaces move up/down and left/right 3 times to confirm the self-calibration before flight.

At this point the gyro is not in ready mode until you give the throttle a short blip 10-15% in order to switch on the

stabilization system. Check that the gyro responds accordingly to the plane when being tilted up/down, left/right

and the roll. (Please see the flying tips down below).

LED indication status

•LED light off (No radio signal)

•LED light flashes slowly (Expert mode)

•Led light turns solid (Beginner mode)

Table of Contents