Installing The Vrpd; Safety Requirements; Proper Use - Bosch Rexroth VT-VRPD-2 Installation & Operation Manual

8/32 Bosch Rexroth AG | Hydraulics

2 Installing the VRPD

2 Installing the VRPD
2.1

Safety Requirements

Proper Use

Operate the VRPD controller card only if it is not damaged and is in proper operating
condition and is applied for its intended purpose. Observe all safety and hazard in-
structions in the included documentation.
When faults occur, which compromise safety and result in changes in operating condi-
tions, shut down the controller card immediately and notify responsible personnel.
Fault free and safe running of the controller card assumes appropriate transport, stor-
age and installation, as well as proper startup and operation.
The VRPD Control Card has been built using the latest technology, and in accordance
with recognized safety standards. Nevertheless, operation may result in hazard to
persons or property if:
The VRPD Controller Card is not used properly.
The VRPD Control Card is not installed, commissioned and operated by qualified
persons.
Changes or modifications are made to the VRPD controller card.
Safety requirements and safety notes are not observed.
The VRPD controller card is intended for industrial use.
The card must not be operated until it has been determined that the system in which
the controller card is installed, meets all applicable standards and safety regulations
for the application.
In European countries: EC Directive 89/392/EWG (Machine Directive)
Operation is permitted only when applicable EMC regulations for the application are
met.
Adherence to limits defined by regulations and standards are the responsibility of the
manufacturer of the system or machine.
In European countries: EC Directive 89/336/EWG (EMC Directive)
In the United States: National Electrical Code (NEC) and National Electrical Manufac-
turers Association (NEMA), as well as local standards should be observed. The op-
erator is required to adhere to the above named standards at all times.
The VRPD is designed to control Electromechanical and Electrohydraulic Drives.
Possible application area's are:
Valve Amplifiers
Proper use requires adherence to the manuals and supplementary documentation,
and observing relevant safety and operating standards.
Installation and Operation | RE 30126-B/09.13