Tuning A Non-Preset Radio Station (Auto Tuning, Manual Tuning); One-By-One Presetting (Manual Preset) - Kenwood HM-383MD Instruction Manual

Hm-383md instruction manual
Table of Contents

Advertisement

26
Tuning a non-preset radio station
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good: AUTO mode
When it is poor due to weak radio waves: MANUAL
mode
1 Select the AUTO or MANUAL mode.
2 Tune a station.
TUNING
DOWN
1
To decrease
frequency
One-by-one presetting
Remote control unit only
1 Perform the procedure in "Tuning a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
(Proceed to step 3 while "MEMORY" is lit.)
3 Select one of the preset numbers from
1 to 30.
P.CALL
4
4 Press the ENTER key again.
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
(Auto tuning, Manual tuning)
AUTO/MONO
7
STOP
TUNING
UP
1
To increase
frequency
(Manual preset)
ENTER
1
2
3
ABC
DEF
¢
4
5
6
GHI
JKL
MNO
7
8
9
PRS
TUV
WXY
0
10
&( )-
QZ
ENTER
÷ In MANUAL mode, FM stations are received in monau-
ral.
Each press alternates the mode.
1 "AUTO" :
Stereo reception ("AUTO" lit)
2 "MANUAL" :
Monaural reception
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
In AUTO mode:
The next preset station can be received automatically ev-
ery time the TUNING UP/DOWN (1 or ¡) key is
pressed.
In MANUAL mode:
Press the TUNING UP/DOWN (1 or ¡) key repeat-
edly until the desired station is received. The desired
station can also be received by holding the TUNING
UP/DOWN (1 or ¡) key depressed until its fre-
quency is displayed.
M E M O R Y
"MEMORY" lights (for approx. 20 sec.)
÷ A maximum of 30 stations of the band presently being
received will be preset.
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
Receiving broadcast station
Playback of tape
("AUTO" not lit)

Advertisement

Table of Contents
loading

Table of Contents