Kenwood HM-383MD Instruction Manual page 43

4
Check the current play mode of the CD player.
All-track high-speed recording
If it is in play mode, stop it.
5
Start recording.
1
Press the menu key.
2
Turn the volume/multi control knob to se-
lect "REC OPTIONS", then press the set/
demo key.
3
Turn the volume/multi control knob to se-
lect "CD = MD", then press the set/demo
key to start high-speed recording.
If you want to control step 5 from the remote,
simply press the MD O.T.E. key once to start
recording.
The recorded audio may skip, noise may be recorded
on the MD or unnecessary tracks may be created de-
pending on the condition of the CD. In such a case,
restart recording at the normal speed.
To interrupt a recording
(Recording and playback will be stopped)
Do not turn power off or apply shock or impact
while "MD WRITING" is displayed. If the power cord
is unplugged before "MD WRITING" disappears, the
recorded or edited data will be lost.
7
stop
Tuning
Mode
7
stop
Tuning
Mode
Single-track high-speed recording
Select the desired CD track and play it.
÷ When step 5 is performed in the middle of CD play-
back, the current track will be recorded from the begin-
ning.
(To record other tracks, repeat steps 4 and 5 for each
track)
Turning the knob switches the display contents.
1 "CD = MD" : Select for high-speed record-
ing of CD onto MD.
2 "CD = TAPE"
3 "TWIN REC"
÷ When either the playback of CD or recording of MD or
tape is stopped, the other operation is stopped auto-
matically.
At the end of the recording
MD recorder : Stop.
÷ One high-speed recording starts, it is not permitted to
record the same disc with high-speed recording for 74
minutes after the start of recording. If you want to
record the same disc immediately, use one-touch edit
recording (recording at normal speed).
W a i t 7 4 m i n .
Time period until high-speed recording
of the same disc is permitted
÷ High-speed recording of more than 100 tracks within 74
minutes is not permitted.
Convenient recording methods
r
43