Tuning To A Non-Preset Radio Station (Auto Tuning, Manual Tuning); One-By-One Presetting (Manual Preset) - Kenwood HM-535 Instruction Manual

Tuning to a non-preset radio station
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good:
AUTO mode
When it is poor due to weak radio waves:
MANUAL mode
1
Select the AUTO or MANUAL mode.
STOP 7
2
Tune a station.
1
TUNING
To decrease
frequency
One-by-one presetting
Remote control unit only
1
Perform the procedure in "Tuning to a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2
Press the ENTER key during reception.
ENTER
(Proceed to step 3 while "MEMORY" is lit.)
3
Select one of the preset numbers from
1 to 30.
4 4
P.CALL
4
Press the ENTER key again.
ENTER
(Repeat steps 1, 2, 3 and 4 to preset other sta-
tions)
22 EN
(Auto tuning, Manual tuning)
AUTO/MONO
1
To increase
frequency
(Manual preset)
1 2 3
4 5 6
7 8 9
10 0
÷ In MANUAL mode, FM stations are received in mon-
aural.
Each press alternates the mode.
1 "AUTO" :
Stereo reception ("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
÷ Normally, use the AUTO (Auto tuning, stereo reception)
mode.
In AUTO mode :
The next preset station can be received automatically
every time the TUNING (1 or ¡) key is pressed.
In MANUAL mode :
Press the TUNING (1 or ¡) key repeatedly until the
desired station is received. The desired station can
also be received by holding the TUNING (1 or ¡)
key depressed until its frequency is displayed.
"MEMORY" lights (for approx. 20 sec.)
÷ A maximum of 30 stations of the band presently be-
ing received will be preset.
÷ If several stations are preset under the same num-
ber, the previous memory is replaced with the latest
memory contents.
Receiving broadcast station Playback of TAPE