Remove Jam Or Debris; Latch The Sort Disk - CUMMINS ALLISON JetSort LX User Manual

Remove jam or debris

Proceed to clear table jam or remove debris from disk pad. Large debris or coins may be
removed from the sort disk pad by hand.
never wipe sort disk or pad, except as instructed on page 36.

Latch the sort disk

Before operating Jetsort LX, latch the sort disk as shown.
DO nOT attempt to force the sort disk onto the sort pad for latching. If the disk
resists being lowered into position, raise it again. Carefully remove coin and
debris from all surfaces and surrounding area before repeating the latching
process.
1. Without forcing, press the sort disk down until it is flush with the sort pad. If disk
resists, repeat cleaning – see message above.
2. Turn latch to lock the disk in place. Latch should be at a full right angle to the
unlatched position, as shown.
Correct: disk is secured
22 | JetSort LX Attended coin sorter | Troubleshooting
®
Sort disk should always be latched properly before restoring
JetSort LX to service. An improperly latched sort disk negatively
impacts performance and may damage the machine.
Incorrect: disk is not secured