Remove Bag(S); Replace Bag(S); Clear Bags - CUMMINS ALLISON JetSort LX User Manual

optional LED above bag handle (not shown) glows red when bag is full. The steps are the
same to change either full or partially full bags. Clear bag(s) from the count screen after
changing. Clear a single bag at a time or clear all bags at once, if all have been changed.

Remove bag(s)

To change a full or partially-full bag:
1. Locate the desired bag station. Hold front edge of full bag to steady it. If coin is near the
top, gently shake bag prior to removing.
2. Holding bag firmly, grasp bag station handle and pull up to release bag.
3. Remove full bag from machine.
4. Seal bag and set aside.
2
1

Replace bag(s)

5. With handle raised, slide a new empty bag over bag holder, cinching bag tightly over
back of bag holder. Seams should be aligned at the front and rear, as shown.
6. Ensure that bag is captured between the holder and the back of the station as you
lower the handle. Bag must hang straight, not twisted in place.
7. Push handle all the way down to its normal position to secure the bag. Tuck bag
bottom into metal divider.
8. Remove and replace other bags as needed.

Clear bags

Clear bag(s) after changing to reset the onscreen bag fill indicator to empty. A single bag
may be cleared or all bags may be cleared at once, if appropriate. Clear reject receptacle
when coin discrimination limit is reached. See
• To clear one bag, select the indicator for the bag you changed, then select the Clear
button.
• To clear all bags at once, select Clear All Bags to reset all bag fill indicators.
A report prints for each bag cleared.
16 | JetSort LX Attended coin sorter | How to use the system
®
5
Errors and warnings on page
7
17.