CUMMINS ALLISON JetSort Series Setup Instructions

Automatic oiler

Table of Contents

JetSort

Automatic Oiler

Setup Instructions

Table of Contents

Need help?

Do you have a question about the JetSort Series and is the answer not in the manual?

Page 1 JetSort ® Automatic Oiler Setup Instructions...
Page 2 JetSort Automatic Oiler ® Machine Preparation High voltage inside. Risk of electric shock. Turn power OFF and unplug before performing preventive maintenance. Customer must provide grounded power line protected by properly grounded 15-amp circuit breaker in compliance with applicable local electrical code. Plug three-prong grounded plug (supplied) into properly grounded three-prong outlet.
Page 3 Setup During setup, use a clean, lint-free towel to remove dispensed oil from the sorting pad. Do not allow oil to remain on sorting disk. Getting Started 1. Plug the machine into an electrical outlet. Turn on JetSort. The JetSort should be in a Batch Ended condition.
Page 4 Set Coins per Oil The frequency setting at which oil is dispensed depends upon the number of coins processed. An average setting is four or five, which is one drop of oil for every 4,000 or 5,000 coins processed. The range can be set between one and 99.
Page 5 Information is subject to correction or change without prior notice. This manual contains proprietary information of Cummins Allison. It is intended solely for the information and use of parties authorized by Cummins Allison to maintain the equipment described herein. Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without express written permission of Cummins Allison.