Connecting The Control Unit And Remote Sampling Head - Cantium Scientific MicroBio MB2 Operating Manual

Operation
Once installed, the MB2-RSH operates in exactly the same way as a
conventional MB2 bioaerosol sampler.
Calibration - Factory or Service Agent only
The MB2-RSH can be calibrated in the same manner as any other MicroBio
bioaerosol sampler.
Disconnect the head and control unit from the cable and return to the
manufacturer or approved agent for calibration. Head units must be
thoroughly cleaned, sterilised and free from any potential contaminant before
return to a calibration agent. Documented evidence of cleaning must be
provided. Please inform the calibration provider of the length of the
connecting cable used for the controller and head combination. It may be
possible to calibrate in situ. The use of the Qualisair ™ qCR kit is required
for this.
Connecting the Control Unit and
remote Sampling Head
The connectors are polarised so that
they can only be connected in the
correct manner. The remote head unit
requires the female connector and the
male connector end of the cable
connects to the control unit.
45