Performance Data Sheet - Culligan Medallist Plus Iron-OX5 Owner's Manual

Culligan Medallist Plus
Important Notice — Read this data sheet and compare the capabilities of the unit to your actual water
treatment needs. Culligan recommends that you have your water supply tested to determine these
needs before purchasing a water treatment unit.
Culligan knows the more informed you are about your water treatment system, the more confident you
will be about its performance. It's because of this and more than seventy years of commitment to our
customers that Culligan is providing this Performance Data Sheet to its customers.
Manufacturer Culligan International Company
9399 W. Higgins Rd., Suite 1100, Rosemont, IL 60018 USA
1-800-CULLIGAN or 1-847-430-2800
www.culligan.com
Substance Reduction
This system has been tested according to NSF/ANSI Standard 42 for the reduction of the substances
listed below. The concentration of the indicated substances in water entering the system was reduced
to a concentration less than or equal to the permissible limit for water leaving the system, as specified
in NSF/ANSI Standard 42.
While testing was performed under standard laboratory conditions, actual performance may vary.
Substance Influent Challenge
Iron
Capacity:
Flow Rate:
Rated Pressure Drop:
Operating Conditions
Water Pressure Limits:
Temperature Limits:
Electrical Characteristics: 120V/ 60 Hz, 35 Watts
The Culligan® Medallist Plus Iron-OX5™ filter system has been tested
and certified by WQA against NSF/ANSI Standard 372, CSA B483.1,
and NSF/ANSI Standard 42 for the effective reduction of iron up to 500
gallons as verified and substantiated by test data.
Performance Indicator: If water flow decreases or a noticeable taste change
occurs, the filter should be reconditioned. If conditions do not improve, contact
your local Culligan Man. He can determine if your filter requires servicing.
Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
Reconditioning cycle Frequency: Replacement frequency is recommended
every three days
but can vary with local water conditions.
Refer to the Installation and Operation Instructions, Parts List and Printed Warranties for more
specific product information. To avoid contamination from improper handling and installation, your
system should only be installed and serviced by your Culligan Man. Performance will vary based
on local water conditions. The substances reduced by this product are not necessarily in your water.
Buyer Signature _______________________
Seller Signature _______________________
®
Iron-OX5 Filter
Concentration
3.0-5.0 mg/L ± 10%
500 gallons
4 gpm
4 gpm @ 5.0 psi
20 - 60 psi (140 - 414 kpa)
33 - 120° F (1 - 50° C)
Reduction Average Reduction
Requirement
0.03 mg/L
Date ____________
Date ____________
Percentage
98.5%
Performance
Data Sheet
01035155 A 09/19
15