Performance Data Sheet - Culligan Medallist Plus Sulfur-OX3 Owner's Manual

Performance
Data Sheet
16
01035157 C 10/20
Culligan Medallist Plus® Sulfur-OX3 Filter
Important Notice — Read this data sheet and compare the capabilities of the unit to your actual water
treatment needs. Culligan recommends that you have your water supply tested to determine these
needs before purchasing a water treatment unit.
Culligan knows the more informed you are about your water treatment system, the more confident you
will be about its performance. It's because of this and more than seventy years of commitment to our
customers that Culligan is providing this Performance Data Sheet to its customers.
Manufacturer Culligan International Company
9399 W. Higgins Rd., Suite 1100, Rosemont, IL 60018 USA
1-800-CULLIGAN or 1-847-430-2800
Substance Reduction
This system has been tested according to NSF/ANSI Standard 42 for the reduction of the substances
listed below. The concentration of the indicated substances in water entering the system was reduced
to a concentration less than or equal to the permissible limit for water leaving the system, as specified
in NSF/ANSI Standard 42.
While testing was performed under standard laboratory conditions, actual performance may vary.
Substance Influent Challenge
Hydrogen Sulfide
Capacity:
Flow Rate:
Rated Pressure Drop:
Operating Conditions
Water Pressure Limits:
Canada:
Temperature Limits:
Electrical Characteristics: 120V/ 60 Hz, 35 Watts
The Culligan® Medallist Plus Sulfur-OX3™ water filter system has been tested and certified by
WQA against NSF/ANSI Standard 372, CSA B483.1, and NSF/ANSI Standard 42 for the effective
reduction of hydrogen sulfide up to 500 gallons as verified and substantiated by test data.
The Culligan® Outdoor Medallist Plus Sulfer-OX3™ water filter system has been tested and
certified by WQA against NSF/ANSI Standard 372 and Standard NSF/ANSI 42 for the effective
reduction of hydrogen sulfide up to 500 gallons as verified and substantiated by test data.
For installations in Massachusetts, the Massachusetts Plumbing Code 248 CMR shall be adhered
to. Consult your licensed plumber for installation of this system. This system and it's installation must
comply with state and local regulations. The use of saddle valves is not permitted.
Performance Indicator: If water flow decreases or a noticeable taste change occurs, the filter should be
reconditioned. If conditions do not improve, contact your local Culligan Man. He can determine if your
filter requires servicing. Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
Reconditioning cycle Frequency:
Reconditioning frequency is recommended every three days but can vary with local water conditions.
Refer to the Installation and Operation Instructions, Parts List and Printed Warranties for more
specific product information. To avoid contamination from improper handling and installation, your
system should only be installed and serviced by your Culligan Man. Performance will vary based on
local water conditions. The substances reduced by this product are not necessarily in your water.
Buyer Signature _______________________
Seller Signature _______________________
Concentration
1.0 mg/L ± 10%
500 gallons
4 gpm
4 gpm @ 2.9 psi
20 - 60 psi (140)
20 - 90 psi (140 - 620 kpa)
33 - 120° F (1 - 50° C)
www.culligan.com
Reduction Average Reduction
Requirement
0.05 mg/L
Date ____________
Date ____________
Percentage
96.2%