Performance Data Sheet - Culligan Aquasential Select Plus Series Owner's Manual

Performance Data Sheet

Culligan ® Aquasential™ Select™ 8" and 10" Cullar
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its performance� It's because
of this and more than seventy years of commitment to customer satisfaction that Culligan is providing this Performance Data Sheet to its customers�
NOTE!
Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
Manufacturer: Culligan International Company
9399 W� Higgins Rd�, Suite 1100
Rosemont, IL 60018 USA
(847) 430-2800
www�culligan�com
Product: Culligan
Substance Reduction
These systems have been tested according to NSF/ANSI Standard 42 for the reduction of the substances listed below�
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standard 42�
While testing was performed under standard laboratory conditions, actual performance may vary�
Substance
Chlorine
Flow Rate:
Rated Pressure Drop:
Operating Conditions
Water Pressure Limits:
Canada:
Temperature Limits:
Electrical Characteristics: 24V/60Hz, 10W
The Culligan ® Aquasential™ Select™ Series 8" and 10" Cullar
certified by WQA against NSF/ANSI Standard 372, CSA B483.1, and NSF/ANSI Standard 42 for the
effective reduction of aesthetic Chlorine Taste and Odor for 8" up to 100,000 gallons and 10" up to
130,000 gallons as verified and substantiated by test data�
Performance Indicator: If water flow decreases or a noticeable taste change occurs, a reconditioning cycle should be
initiated� If conditions do not improve, contact your local Culligan dealer� They can determine if your filter requires servicing�
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the
system�
Media Replacement Frequency: Replacement frequency will vary with water conditions�
Refer to your Owner's Guide and printed limited Warranties (P/N 01040677) for more specific product information� To
avoid contamination from improper handling and installation, your system should only be installed and serviced by your
Culligan Dealer� Performance will vary based on local water conditions� The substances reduced by this product are not
necessarily in your water�
Buyer Signature _________________________________ Date __________
Seller Signature _________________________________ Date __________
14
01040677 B 07/21
®
Aquasential™ Select™ 8" and 10" Cullar
Influent Challenge pH
2�0 mg/L ± 10%
5�9 gpm
5�9 gpm @ 5 psi
20 - 120 psi (140 - 860 kpa)
20 - 90 psi (140 - 620 kpa)
33 - 120° F (1 - 50° C)
® Filters
®
Filters
Effluent pH Requirement
® Filters have been tested and
≥50%