Adjusting The Rear Wheel Toe-In; Cooling System Maintenance; Cooling System Safety; Checking The Cooling System - Toro Groundsmaster 4300-D Operator's Manual

4. Turn the key in the ignition switch to the O
position, start the engine, and rotate the cam
hex in either direction until the wheels cease
rotation.
5. Tighten the locknut to secure the adjustment.
6. Turn the key in the ignition switch to the O
position, remove the jack stands, and lower the
machine to the shop floor.
7. Test drive the machine to make sure that it does
not creep.
Adjusting the Rear Wheel
Toe-in
Service Interval: Every 800 hours
1. Rotate the steering wheel so that the rear
wheels are straight ahead.
2. Loosen the jam nut on each end of the tie rod
(Figure 66).
Note:
The end of the tie rod with the external
groove is a left-hand thread.
Figure 66
1. Wrench slot
2. Tie rod
3. Using the wrench slot, rotate the tie rod.
4. Measure the distance at the front and rear of the
rear wheels at axle height.
Note:
The distance at the front of the rear
wheels should be less than 6 mm (1/4 inch) of
the distance measured at the rear of the wheels.
5. Repeat procedure as required.
N
FF
g031686
3. Jam nut
Cooling System
Maintenance

Cooling System Safety

CAUTION
Discharge of hot, pressurized coolant or
touching a hot radiator and surrounding parts
can cause severe burns.
• Do not remove the radiator cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the radiator
cap is cool enough to touch without
burning your hand before removing the
radiator cap.
• Do not touch the radiator and surrounding
parts that are hot.
DANGER
Swallowing engine coolant can cause
poisoning.
• Do not swallow engine coolant.
• Keep out of reach from children and pets.
Checking the Cooling
System
Service Interval: Before each use or daily—Check
the level of coolant in the expansion
tank and clean debris off the screen,
oil cooler, and front of the radiator.
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol antifreeze. The
capacity of the cooling system is 9.5 L (10 US qt).
DANGER
The rotating fans and drive belts can cause
personal injury.
• Do not operate the machine without the
covers in place.
• Keep fingers, hands, and clothing clear of
the rotating fan and drive belt.
• Shut off the engine and remove the ignition
key before performing maintenance.
51