Checking The Tire Pressure; Checking The Torque Of The Wheel-Lug Nuts - Toro Groundsmaster 4300-D Operator's Manual

Fuel Tank Capacity
Fuel tank capacity: 53 L (14 US gallons)
Adding Fuel
Note:
If possible, fill the fuel tank after each use.
This will minimize possible buildup of condensation
inside the fuel tank.
Figure 13
Note:
Fill the tank until the level is 6 to 13 mm (1/4 to
1/2 inch) below the bottom of the filler neck.

Checking the Tire Pressure

Service Interval: Before each use or daily
The correct air pressure in the front and rear tires is
83 to 103 kPa (12 to 15 psi).
Important:
Maintain pressure in all tires to
ensure a good quality of cut and proper machine
performance. Do not underinflate the tires.
Check the air pressure in all the tires before
operating the machine.
g031603
Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first hour
After the first 10 hours
Every 250 hours
WARNING
Failure to maintain the proper torque of the
wheel nuts could result in failure or loss of a
wheel, and may result in personal injury.
Torque the front and rear-wheel nuts to 94 to
g031599
122 N·m (70 to 90 ft-lb) after the first hour of
operation, after the first 10 hours of operation,
and every 250 hours thereafter.
22
Figure 14
g001055