Raising the Machine
Use the following as points to jack up the machine:
•
Front of the machine—rectangular pad, under
the axle tube, inside each front tire
Figure 44
1. Front jacking point
•
Rear of the machine—rectangular axle tube on
the rear axle.
Lubrication
Greasing the Bearings and
(Figure
44).
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease fitting locations and quantities are as
follows:
•
Pump driveshaft U-joint (3)
g031850
•
Cutting unit lift arm cylinders (2 each)
•
Lift arm pivots (1 each)
•
Cutting unit carrier frame pivot (1 each)
42
(Figure
45)
Figure 45
(Figure
Figure 46
(Figure
46)
(Figure
g003962
46)
g011612
47)