Product Overview; Controls - Toro Groundsmaster 4300-D Operator's Manual

Product Overview

Controls

Parking Brake
To engage the parking brake,
the brake pedal and press the top forward to latch. To
release the parking brake, press the brake pedal until
the parking-brake latch retracts.
1. Traction pedal
2. Mow-speed limiter
3. Spacers
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Mow Speed Limiter
When the mow speed limiter
controls the mow speed and allows the cutting decks
to be engaged. Each spacer adjusts the mowing
speed by ½ mile per hour. The more spacers you
have on the top of the bolt, the slower you will go. For
transport, flip back the mow speed limiter and you will
have maximum transport speed.
(Figure 5) push down
Figure 5
4. Brake pedal
5. Parking brake
6. Tilt-steering pedal
5) controls the forward and
position.
AST
(Figure 5) is flipped up it
Brake Pedal
Press the brake pedal
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal (Figure 5) down, and the steering tower toward
you to the most comfortable position, and release the
pedal.
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold the switch down to automatically move the
engine to High or Low idle, depending on which end
of the switch that you press.
3
4
g003955
5
6
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Key Switch
The key switch
O /P , and S
N REHEAT
Lower Mow/Raise Control Lever
This lever (Figure
decks and also starts and stops the mowers when the
mowers are enabled in the mow mode. When starting
the decks in the down position, this lever will turn the
decks on if the PTO and the mow speed limiter are
engaged.
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 6).
13
(Figure 5) to stop the machine.
(Figure 6) has 2 modes to
2 1
Figure 6
4. Enable/disable switch
5. Engine-speed switch
6. Headlight switch
(Figure 6) has 3 positions: O
.
TART
6) raises and lowers the cutting
G021208
g021208
,
FF