Adjusting The Roller Scraper (Optional); Installing The Mulching Baffle; (Optional) - Toro Groundsmaster 4300-D Operator's Manual

2
Removing the Shipping
Blocks and Pins
No Parts Required
Procedure
1. Remove and discard the shipping blocks from
the cutting decks.
2. Remove and discard the shipping pins from the
cutting deck suspension arms.
Note:
The shipping pins stabilize the cutting
decks during shipping; remove the pins before
operating the machine.
3
Adjusting the Roller
Scraper (Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work
best when there is an even gap of 0.5 to 1 mm (0.020
to 0.040 inch) between the scraper and roller.
1. Loosen the grease fitting and the mounting
screw (Figure 3).
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until a gap of 0.5 to
1 mm (0.020 to 0.040 inch) is achieved between
the rod and the roller.
1
2
3
Figure 3
3. Grease fitting
3. Torque the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
4
Installing the Mulching
Baffle (Optional)
No Parts Required
Procedure
1. Thoroughly clean debris from the mounting
holes on the rear wall and left side wall of the
chamber.
2. Install the mulching baffle in the rear opening
and secure it with 5 flange head bolts
1. Mulching baffle
3. Verify that mulching baffle does not interfere with
the tip of the blade and does not protrude inside
the surface of the rear chamber wall.
DANGER
Using the high-lift blade with the
mulching may cause the blade to break,
resulting in personal injury or death.
G011346
g011346
Do not us the high-lift blade with the
mulching baffle.
11
(Figure
1
G011347
Figure 4
4).
g011347