Installing The Oil Cooler - Toro Greensmaster TriFlex 3400 Operator's Manual

6. When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
Note:
After the battery has been activated,
add only distilled water to replace normal loss,
although maintenance-free batteries should not
require water under normal operating conditions.
Important:
Failure to correctly activate the
battery may result in battery gassing and/or
premature battery failure.
7. Install the vent caps.
8. Place the battery on the battery tray and secure
it with the battery clamp and fasteners removed
previously.
9. Install the positive cable (red) to the positive (+)
terminal and then the negative cable (black)
to the negative (–) terminal of the battery and
secure them with the bolts and nuts
Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
WARNING
Incorrect battery cable routing could damage
the tractor and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
1. Negative (-)
2. Positive (+)
(Figure
Figure 9
6

Installing the Oil Cooler

Optional
Parts needed for this procedure:
Oil Cooler Kit—Greensmaster 3400 Series Traction
–
Unit (Part No. 117-9314 [purchased separately])
Procedure
If you are operating the machine in hot climates,
where the ambient temperature is above 29°C (85°F),
or using it for heavy-duty use (mowing other than
9).
greens, such as fairways or verticutting), install the
optional hydraulic oil cooler kit (Part No. 117-9314).
g005098
13