Storage; Storage Safety; Preparing The Machine For Storage - Toro Greensmaster TriFlex 3400 Operator's Manual

2. Move the functional-control lever to the
T position.
RANSPORT
3. Ensure that the backlap lever is set to the
F (F) position.
ORWARD
4. Get off the seat.
5. Hold the raise/lower mow control in the R
position.
6. Turn the ignition switch to the R
7. Count the codes as they begin to flash (you may
release the raise/lower mow control once they
begin flashing).
When finished, turn the key to the O
diagnostic mode.
Determining the Error Code
The system will display the last 3 faults that occurred
in the last 40 hours. It displays the faults through a
series of blinking lights, as follows:
•
If there are no faults, the light will blink steadily at
a medium rate without pauses (1 Hz).
•
If there is a fault, it will first blink the tens place,
followed by a pause, followed by the ones place.
For the following examples, a # represents a blink.
Examples:
– If the code is 15, the blink pattern will be
#_#####
– If the code is 42, the blink pattern will be
####_##
– If the code is 123, the blink pattern will be
############_###
•
If there are more than 1 fault, the tens place of the
next fault will begin after a pause after the ones
place of the first fault.
Note:
The system stores only the 3 most recent
fault codes.
For a list of error codes, refer to your authorized Toro
distributor or the Service Manual.

Storage

Storage Safety

•
AISED
position.
UN
•
Preparing the Machine for
position to exit
FF
Storage
If you wish to store the machine for a long period of
time, the following steps should be performed prior
to storage:
50
Shut off the machine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
1. Refer to Storage Safety (page
2. Remove accumulations of dirt and old grass
clippings. Sharpen the blades and bedknives, if
necessary; refer to the cutting unit Operator's
Manual. Use a rust preventive on bedknives and
blades. Grease and oil all lubrication points.
3. Block up the wheels to remove any weight on
the tires.
4. Drain and replace the hydraulic fluid and filter
and inspect the hydraulic lines and fittings.
Replace, if necessary; refer to
the Hydraulic Fluid and Filter (page 43)
Checking the Hydraulic Lines and Hoses (page
44).
5. All fuel should be removed from the fuel tank.
Run the engine until it stops from lack of fuel.
Replace the fuel filter; refer to
Fuel Filter/Water Separator (page
6. While the engine is still warm, drain the oil from
the crankcase. Refill it with fresh oil; refer to
Changing the Engine Oil and Filter (page
7. Clean dirt and chaff from the cylinder, cylinder
head fins, and blower housing.
8. Remove the battery and charge it fully. Either
store it on the shelf or on the machine. Leave
the cables disconnected if it is stored on the
machine. Store the battery in a cool atmosphere
to avoid quick deterioration of the charge in the
battery.
9. If possible, store the machine in a warm, dry
location.
50).
Changing
and
Replacing the
36).
34).