Toro Greensmaster TriFlex 3400 Operator's Manual page 45

Figure 45
1. Prop (not provided)
Installing the Cutting Units
1. Lift up on the footrest and swing it open, allowing
access to the center cutting unit position
46).
CAUTION
The footrest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the footrest seats while it is open.
Figure 46
1. Footrest—closed
2. Position the cutting unit under the center
suspension arm.
3. With the latches on the suspension-arm bar
pointing up (i.e., open)
suspension arm down so that the bar fits over
the bar across the top of the cutting unit
48).
g014596
2. Bedbar-adjusting-screw
nut (2)
(Figure
g014602
2. Footrest—open
(Figure 47), push the
(Figure
1. Latch—closed position
2. Suspension-arm bar
1. Suspension-arm bar
4. Close the latches down and around the
cutting-unit bar and lock them in place
47).
Note:
You can hear a click and feel when the
latches are properly locked in place.
5. Coat the spline shaft of the cutting unit motor
with clean grease
6. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear a click from both
sides of the motor
45
Figure 47
3. Latch—open position
Figure 48
2. Cutting-unit bar
(Figure 49).
(Figure 49).
g014609
g014611
(Figure