Toro Greensmaster TriFlex 3400 Operator's Manual page 34

checking. If the oil level is at or below the Add mark
on the dipstick, add oil to bring the oil level to the F
mark. Do not overfill.
Important:
Keep the engine oil level between the
upper and lower limits on the oil gauge; the engine
may fail if you run it with too much or too little oil.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag
(Figure 30).
Important:
Remove the dipstick while filling
the engine with oil. When adding engine
oil or filling oil, there must be clearance
between the oil fill device and the oil fill
hole in the valve cover as shown in
29. This clearance is necessary to permit
venting when filling, which prevents the oil
from overrunning into the breather.
Figure 29
1. Note clearance
ULL
Figure
1. Filler cap
3. Push the dipstick into the tube and make sure it
is seated fully.
4. Remove the dipstick from the tube and check
the oil level
Note:
from the valve cover and slowly add enough
oil to raise the level to the F
dipstick.
Add the oil slowly and check the level often
during this process. Do not overfill.
5. Replace the dipstick.
6. Start and run the engine at idle for 30 seconds,
then shut the engine off. Wait 30 seconds, then
repeat steps
7. Install the filler cap and dipstick firmly in place.
g002373
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 100 hours
1. Remove the drain plug and let oil flow into a
drain pan. When the oil stops, install the drain
plug
34
Figure 30
2. Dipstick
If the oil level is low, remove the filler cap
2 through 5.
(Figure 31).
g014618
mark on the
ULL