Adjusting The Audio Level; Vol Function Assignment; Selecting Passband Width - Icom IC-G86 Advanced Manual

3
ADVANCED OPERATION

Adjusting the audio level

z Rotate [VOL]* to adjust the audio level.
• The display shows the audio level while adjusting.
L If the squelch is closed, hold down [MONI] while
adjusting the audio level.
[VOL]
* Use [VOL] or [Y]/[Z], depending on the setting of the "Dial
assignment" in the Initial Set mode. (p. 8-6)

Selecting passband width

Set both the transmission and reception passband
width to wide or narrow.
1. Push [FUNC], and then push [SET] to enter the
Set mode.
2. Push [Y] or [Z] to select the passband width item
(W/n).
3. Rotate [VOL] to select the passband width.
• "W": Wide (FM mode)
• "n": Narrow (FM-N mode)
4. Push [# ENT] to exit the Set mode.
The "Passband width" item in the Set mode
(FM mode is selected) (FM-N mode is selected)
[VOL] function assignment
[VOL] can be used as a channel selector instead of
[Y] and [Z], to suit your preference. However, when
[VOL] functions as a channel selector, [Y] and [Z]
function as volume controls.
1. Hold down [ ] for 1 second to turn OFF the power.
2. While holding down [Y] and [Z], turn ON the power
to enter the Initial Set mode.
3. Push [Y] or [Z] to select the dial assignment item
(tOP).
4. Rotate [VOL] to select an option.
5. Push [# ENT] to exit the Initial Set mode.
[VOL] and [Y]/[Z] function as described below,
depending on the option.
Option
tOP.VO Volume control
tOP.di Channel selector
The "Dial assignment" item in the Set mode
[DIAL]
[VOL] functions as the volume control.
[VOL] functions as the channel selector.
3-2
[VOL] [Y]/[Z]
Channel selector
Volume controls