Toro 34230 Operator's Manual page 54

1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Lower the ramp.
4. Raise the operator platform.
5. Back the machine up the ramp
1. Back the machine up the
ramp.
6. Secure the machine; refer to
Machine for Transport (page
Securing the Machine for
Transport
WARNING
Securing the machine at any upper frame
location could cause the parking brake to not
function properly, which could cause serious
injury or death.
Only use the front tie-down locations at the
lower frame to secure the front of the machine.
Only use the rear tie-down locations at the
back of the frame to secure the back of the
machine.
Note:
Refer to the chemical-warning-product
label(s) before transporting the machine and follow
all local/state/federal requirements for transporting
chemicals.
Note:
Ensure that the spreader-hopper cover and the
spray wand are secure before transporting.
1. At the left side of the machine, ensure that the
shutoff valve for the sprayer tank is closed and
the drain plug is secure. At the right side of the
machine, ensure that the pump-shutoff valve is
closed.
2. Shut off the engine, remove the key, and engage
the parking brake.
3. Close the fuel valve and block the tires.
(Figure
Figure 67
2. Walk the machine forward
down the ramp.
Securing the
54).
4. Use the tie-down points on the machine to
securely bind the machine to the trailer or truck
with straps, chains, cable, or ropes
Refer to local regulations for trailer and tie-down
requirements.
67).
g306402
1. Front tie-down points
54
(Figure
Figure 68
2. Rear tie-down points
68).
g033507