Toro 34230 Operator's Manual page 15

Wide-Spray Pattern Lever
The wide-spray pattern lever is located on the control
console (Figure 12).
•
To turn O the sprayer in a wide-spray pattern (the
N
right and left nozzles), pull the wide-spray pattern
lever toward you.
•
To turn O the sprayer, push the wide-spray
FF
pattern lever away from you.
Spray-Wand Trigger and Trigger Lock
The spray-wand trigger and trigger lock are located
on the bottom of the spray-wand handle
and Figure 13).
•
To use the spray wand, hold the handle of the
wand squeeze the trigger.
•
To lock the trigger to the O
the trigger against the handle and then latch the
trigger lock over the trigger; to unlock the trigger,
unlatch the trigger lock from the trigger.
•
Release the trigger to stop the spray.
1. Trigger lock
2. Spray-wand handle
Sprayer and Information Display
The sprayer and information display is located to
the right of the throttle, at the bottom of the control
console (Figure 12).
The sprayer and information display shows the
following information:
•
Sprayer controller firmware version
•
Hour meter for the engine
•
Hour meter for the sprayer-pump motor
•
Battery voltage
•
Spray-system pressure
•
Fault codes
(Figure 12
position, fully squeeze
N
Figure 13
3. Trigger
Sprayer-Pump Switch
The sprayer-pump switch is located to the left of the
hour meter and spray pressure display, on the control
console (Figure
Use the sprayer-pump switch to start the electric
motor that drives the sprayer pump and recirculation
pump, adjust the sprayer system pressure, and shut
off sprayer pump and recirculation pump motors.
Spray-Wand Pressure Control
The spray-wand pressure control is located to the
right of the impeller-speed display, at the right side of
the control console
Use the spray-wand pressure control the spray-system
pressure at the spray wand.
Tank Drain Valve
The tank drain valve is located at the left side and
under the sprayer tank
Use the tank drain valve to empty the sprayer tank
of liquid chemicals.
g304906
1. Handle (open position)
2. Tank drain valve
•
To open the valve, rotate the handle of the tank
drain valve 90° clockwise (lever in-line with valve).
•
To close the valve, rotate the handle 90°
counterclockwise.
Sprayer-Pump-Supply Valve
The sprayer-pump-supply valve is located at the
right side of the machine and under the sprayer tank
(Figure 15).
15
12).
(Figure 12).
(Figure 15).
Figure 14
3. Sprayer tank
g027226