Toro 34230 Operator's Manual page 30

Emptying the Spreader
Removing the Impeller
1. Move the machine to a level surface, move
motion-control lever to the N
shut off the engine, wait for all moving parts to
stop, remove key, and engage parking brake.
2. Empty the hopper by scooping out as much of
the material as possible.
3. Remove the 4 thumbscrews that secure the front
cover ( below the impeller) to the chassis, and
remove the cover
Figure 32
1. Forward cover
2. Clip nut
4. Remove the drive pin that secure the impeller to
the shaft of the impeller motor, and remove the
impeller from the shaft
34).
Figure 33
1. Drive pin
2. Shaft
position,
EUTRAL
(Figure 32).
3. Thumb screw
(Figure 33 and Figure
3. Impeller
5. Place a shallow pan under the shaft of the
impeller motor
Disconnecting the Rate-Gate Linkage
g033530
1. Push the locking sleeve for the gate cable
rearward and lift the cable up from the ball stud
of the rate-gate linkage
g027324
30
Figure 34
(Figure 34).
(Figure 35).
g027325