Toro 34230 Operator's Manual page 26

Figure 23
Spreader Firmware Screen
Figure 24
Spreader Hours Screen
Default Spreader Screen
The default screen appears after the initial start-up
screens.
Figure 25
Spreader default screen
1. Default screen—impeller motor is shut off
Spreader Motor Screen
The spreader motor screen appears if the impeller
control switch is tapped.
Note:
If the motor is run for eight seconds, the default
screen displays.
g305692
Using the Impeller Control Switch
g305693
1. Impeller Control Switch
Use the impeller control switch
the electric motor that drives the impeller, adjust the
impeller-motor speed, and shut off the impeller motor.
•
Tap the top of the impeller control switch to run
the impeller motor.
•
Tap the top of the impeller control switch to raise
the impeller rotation speed.
•
Tap the bottom of the impeller control switch to
lower the impeller rotation speed.
g305459
•
Push the bottom of the impeller control switch for
1-second to shut off the impeller motor.
Before Operating the Spreader
Before you start using the spreader, calibrate the
spreader for the material that you will disperse; refer
to Calibrating the Spreader (page
Important:
Prior to filling the hopper, verify that
you have set the proper spreader-application rate.
26
Figure 26
Spreader Motor Screen
Figure 27
2. Spreader and information
display
(Figure
27).
g305328
g305645
27) to start