Toro 34230 Operator's Manual page 45

Figure 52
1. Sprayer-tank cap
2. Filler neck
3. Plug
3. Determine the amount of water needed to mix
the amount of chemical needed as specified by
the chemical manufacturer.
4. Open the tank cap on the spray tank
5. Add 3/4 of the required water to the sprayer tank
through the filler neck.
Important:
Always use fresh, clean water
in the spray tank. Do not pour chemical
concentrate into an empty tank.
6. Rotate the pump-shutoff valve clockwise to the
O position (Figure
PEN
Figure 53
1. Strainer (sprayer tank)
g027391
4. Drain valve
5. Valve handle
(Figure 52).
53).
g027392
2. Pump-shutoff valve
7. Start the engine and set the throttle midway
between the S
8. Set the sprayer-pump switch to the O
(Figure 54).
1. Agitation-bypass lever
2. Narrow-spray pattern lever 5. Sprayer-pump switch
3. Wide-spray pattern lever
9. Move the throttle to the F
10. Pull the tank-agitation lever to the O
Note:
The water in the tank will circulate.
11. Add the specified amount of chemical
concentrate to the tank as directed by the
chemical manufacturer.
Important:
wettable-powder chemical, mix the
powder with a small amount of water to form
a liquid slurry before adding the chemical
mixture to the tank.
12. Add remaining water to the tank and install cap
onto the filler neck of the tank.
Note:
Allow the content of the sprayer tank to
mix thoroughly.
Emptying the Sprayer Tank
Operator supplied equipment:
•
A drain hose with a 1/2–14 inch NPT male coupling
•
A drain container (capacity varies with remaining
sprayer tank content)
•
PTFE thread sealant
1. Move the machine to a level surface at the
designated area for emptying and cleaning the
sprayer tank, move motion-control lever to the
N position, shut off the engine, wait for all
EUTRAL
45
and F positions.
LOW AST
Figure 54
4. Hour meter and spray
pressure display
position.
AST
N
If you are using a
position
N
g305521
position.