2-7. DETAILS OF CONTROL COMMANDS
This section describes various control commands and parameters following after the commands.
<CR> and <CR><LF> denote termination code.
2-7-1. Initial settings
(1) [RES]
Contents:
Format:
Parameter:
Return value format:
Description and others:
(2) [RS-]
Contents:
Format:
Parameter:
Return value format:
Description and others:
(3) [SYS]
Contents:
Format:
Parameter:
Return value format:
Description and others:
To initialize
RES0628<CR>
Key code (Enter "0628" when the key code is enabled or disabled.)
None
ok<CR><LF>
The results of the command will be disabled after turning OFF the power.
RS line test
RS-<CR>
None
ok<CR><LF>
RS-232C<CR><LF> (for the RS-232C)
or RS-485<CR><LF> (for the RS-485) (When properly received)
Models, etc.
SYS<CR>
None
WGA-680A-a, xx.xx, yyyyyyyyy<CR><LF>
The contents of the return value is as follows.
0: No options
1: Reserved
2: With RS-232C, TEDS supported
3: With RS-485, TEDS supported
4: Reserved
Serial No. (9 digits)
Character strings (0 to 9, A, B, and C)
Program version
When the value has no 10th digit, it is
filled with "0s" from the head.
Options
Model of the product
20
IM-A-1060G