Installation In Floor To Ceiling Kitchen; Preparing Corner Fridge - Norcool 60000011 Operating & Installation Instructions Manual

8. Installation
20
Fitting furniture sides. Drill hole from the inside of the sidewalls through bushings
in external steel plate using Ø4 mm drill. NOTE! Drilling and screwing must not be
done at places in the sidewalls other than in through bushings since such may
ruin the design and insulating capability. Take into account the furniture sides
thickness to avoid screw through the furniture sides. Position furniture sides level
with upper edge of corner fridge and pull as far forwards towards furniture front
as possible to minimize gap between furniture front and furniture side. To avoid
over-tighten and damaging plastic bushings or their hold in the furniture sides
we recommend using hand tools. Attach the furniture sides by using the screws
(4X35mm). The screw will extend approximately 13mm into the furniture sides.
Press the supplied plastic caps into the covers to conceal the screw heads.

8.6 Installation in floor to ceiling kitchen

When installing a corner fridge in a floor to ceiling kitchen, an extra air grille and
air conduit must be fitted to ensure sufficient air circulation above and below.
Place the air duct on the roof of the corner fridge. Integrate the corner fridge as
described in chapter 3. Cut a hole in the front panel of the door and the base for
mounting the air vent. Make sure the air vent is placed by the air duct outlet. When
installing the corner fridge in a kitchen that is 2.10 m, do not use the supplied air
vent and extra air duct outlet over the roof element.
8.7 Preparing corner fridge (for all models)
1. Preparation. Insert plastic plugs supplied into all open holes and bushings.