Norcool 60000011 Operating & Installation Instructions Manual page 17

8. Installation
17
supplied in pre-drilled holes on upper and lower sides of the door. Insert plastic
plug in oblong hole in middle of hinge side to secure panel even better.
3. Handle Secure stainless steel handle using 3 screws supplied in pre-drilled holes
in door panel.
4. Cabinet door. Remove hinge retaining screws in floor and ceiling on side
selected for hinges using Allen key supplied. Open hinges fitted on fridge door.
Hold the door in the open position while inserting hinge screws through holes in
hinges. Finger tighten up to (not completely tightened) floor and ceiling. NOTE:
If working alone, place a support under fridge door at correct height for hinges.
Allow door to rest on this while installing hinges into place.
Light switch support piece (see Fig. 7) is mounted at the top of the door and
prepared for right-hinged door. If you want to change the door from right to left,
this plastic piece (2) must be moved to the opposite end of the door. Remove the
screws (3) and move the piece to the opposite end and fit the screw in the ready-
drilled holes.
5. The magnetic seal can be compressed after being packed and transported. It
will return to its original shape a while after being unpacked. Door can be adjusted
using adjustment plate supplied if the seal is compressed - see fig. 6B. If the mag-
netic seal is pressed too hard on door seal or is twisted; open door 90° and loosen
hinge screws to floor/ceiling, move adjustment plate inwards between hinge and
ceiling/floor and screw securely. See fig. 6A.
6. Adjustment and sealing. Door can be adjusted sideways to correct position and
then securely screwed. Examine whether the door can close properly. If you can
pull a sheet of paper out through the closed door without any great resistance,
then the door ought to be further adjusted.