Norcool 60000011 Operating & Installation Instructions Manual page 21

8. Installation
21
2. Positioning shelves. Position wire shelves/baskets at desired height (same
height both sides), in side wall shelf rests. Insert wire basket such that the glass
shelf rest (flat iron) faces the centre of the fridge. Remember difference between
right and left shelves. Wire shelves must be fixed into holes in fridge walls (for
centring) using white plastic plugs. Seal remaining wire shelf holes with white
sealing plugs. Place 2 anti-slip pads (silicon pads) per triangular shelf approx. 7
cm from each side wall edge on the glass shelf rest (flat iron) on which the glass
shelves will rest. Where glass shelves are required, place 4 anti-slip pads per tri-
angular shelf.
3. Glass shelves. Fit white front profile on all glass shelves and place on shelf rests
in fridge. NOTE! Exercise caution when removing glass shelf for cleaning. Do not
lift shelf by profile, as this is loose! Recommended shelf position (from top) for
best utilisation:
shelf rest 1: split glass shelf
shelf rest 2: full glass shelf
shelf rest 4: full glass shelf
shelf rest 6: baskets
shelf rest 8: full glass shelf
Leave the corner fridge inactive after installation for approx. 4 hours before con-
necting to the mains electricity. This is necessary to allow the oil to recollect in the
compressor after transport and installation. When you start your corner fridge for
the first time it will take about 3 minutes before the compressor starts, and it can
take up to 24 hours before it reaches a temperature of approx. 4 °C. To measure
temperature, place a thermometer in a glass of water in the fridge. This is to simu-
late the temperature of the food inside.
If kept very full or the door is opened and closed frequently, or the ambient tem-
perature is high, compressor running time will increase and it will take longer to
reach the temperature set. So keep the door closed as much as possible at all
times.