Installation Of Furniture Sides - Norcool 60000011 Operating & Installation Instructions Manual

8. Installation
19
2. Fitting furniture front. Drill holes from
the inside of the door through bushings
in external steel plate using Ø4 mm drill.
NOTE! Drilling and screwing must not be
done at places in the door other than in
through bushings since such may ruin the
design and insulating capability. Take into
account the furniture front thickness to
avoid screw through the furniture front.
Position furniture front(s) on a level surface.
Check up/down for fronts and handle posi-
tion. Position fridge door correctly on furni-
ture front(s). If in doubt about positioning,
fit fridge door to cabinet and check correct
positioning in relation to cornice seal and
side plates. To avoid over-tighten and dam-
aging plastic bushings or their hold in the
furniture front we recommend using hand
tools. Attach the furniture front by using the screws (4X45mm). The screw will
extend approximately 9mm into the furniture front. Press the supplied plastic caps
into the covers to conceal the screw heads.
3. Cabinet door. Remove hinge retaining screws in floor and ceiling on side selected
for hinges using Allen key supplied. Open hinges fitted on fridge door. Hold the
door in the open position while inserting hinge screws through holes in hinges.
Finger tighten up to (not completely tightened) floor and ceiling - see fig. 5.
NOTE: If working alone, place a support under fridge door at correct height for
hinges. Allow door to rest on this while screwing hinges into place.
4. Handle. The desired handle must be fastened vertically 25 mm from the outer
edge of the fridge door to the centre hole. The screw length depends on the han-
dle and thickness of the furniture panel (thickness of fridge door is 35 mm). Drill
the proper number of holes. Washers should be used for better fastening. Thread
washer on screw and fasten with handtool.
5. Air grilles. Cut an opening in plinth for air grille. The opening
must be 448 mm x 56 mm.
8.5 Fitting furniture sides (see figure 9)
1. Preparation. Corner fridge must be in place without shelves and other internal
fixtures in kitchen with door and front fitted.