Table of Contents
Advertisement
8. Installation
16
installation! Screw back wall into place using the 5 white screws supplied with
plastic washers.
NOTE! Press back wall firmly whilst tightening screws.
Make sure that the electric cable is free.
8.2 Installing full-cover stainless steel elements for freestanding corner fridge
cabinet (see figure 3)
Stainless steel side plates
1. Preparation The corner fridge must be laid on its back with the door opening
upwards to fit the stainless steel elements on to the side walls. Lay a piece of card-
board or paper on the floor to prevent scratches. Make sure that the electric cable
from the top of the corner fridge is free, place a piece of cardboard in between the
top of the corner fridge and the floor.
NOTE: Do not remove the styrofoam from side plates!
2. Securing stainless steel side plates. Mount the stainless steel side plates onto
the side walls. Check elements are positioned correctly and secure with 8 (4,8mm
x 16mm) self-tapping screws supplied. Screw these into floor and ceiling in slots
on the stainless steel side plates using an electric screwdriver. Raise corner fridge
up for remaining installation. Go back to point 8.1 and continue with the rest of this
page. Stainless steel door panel (see figure 4)
1. Hinges. Unscrew the screws for the hinges, upper and lower (point 2 in fig. 4).
Then mount the hinges on the door. Remember the difference between right and
left hinge!
2. Secure door panel. Lay door panel on a level surface, preferably cardboard, to
prevent scratches. Check that the handle side is not on same side as hinges. Posi-
tion the fridge door in middle of panel and screw into place with 6 of the screws
- Quick Links:
- Troubleshooting and Service
Hide quick links:
Advertisement
Table of Contents
