Safety Rules And Warnings - Norcool 60000011 Operating & Installation Instructions Manual

2. Safety rules and warnings

6
THE MANUFACTURER OF THE PRODUCT CANNOT BE HELD RESPONSIBLE FOR
DAMAGE THAT IS DUE TO THESE SAFETY RULES AND WARNINGS NOT BEING
FOLLOWED.
1. Read the use and installation instructions carefully before you start using the
product.
2. This product is intended for private use. The manufacturer cannot be held
responsible for damage in consequence of erroneous or unintended use of the
product.
3. Persons, who due to their mental or physical conditions, or due to their inexpe-
rience or lack of knowledge, are not in a condition to operate the cabinet in a
safe manner, must not use this cabinet without supervision or guidance from a
responsible person.
4. The product is not a toy! Due to the risk of injury, you must not let children
play with or in the vicinity of the product or play with the buttons. Have small
children under supervision while you are using the product. Older children may
only use the product if it has been explained to them how they can use it safely
and are familiar with the dangers of erroneous use.
5. Check that the product does not have any visible damage. Do not install or
use a damaged product. Contact the supplier immediately for further advice
before you install/connect up the power cord.
6. The product contains the coolant Isobutane (R600a), a natural gas that is envi-
ronmentally friendly. (R600a), that no parts of the cooling system have been
damaged during transport or installation. Leaking coolant can injure the eyes.
If the product has been damaged:
a. Avoid open flames and everything that can create sparks.
b. Disconnect the power cord.
c. Air out the room where the product is located, for several minutes.
d. Contact the supplier for further advice.
The more coolant a product contains, the larger the room it should be placed
in. Leaking coolant can form a flammable gas-air mixture in a room that is too
small. According to the EN378 standard, the room must have at least 1 m3 for
each 8 g of coolant. The quantity of coolant in the device is specified on the
type plate on the inside of the product.
7. Before you connect up the power cord, you must check that the information on
the type plate (voltage and connected load) accord with the power grid. This
information must match up in order to avoid risks of damage to the product.
Contact a qualified electrician if you have doubts.
8. Guarantees for the product's electrical safety may only be given when there is
an uninterrupted connection between the product and an effective grounding
system that complies with the applicable local and national regulations. It is
extremely important that this fundamental safety requirement be fulfilled and
R600a