Installation; Installing Cabinet - Norcool 60000011 Operating & Installation Instructions Manual

8. Installation

15

8.1 Installing cabinet

When installing the corner fridge, do NOT screw or drill anywhere else than shown
in the manual. If you do so it can ruin the construction and isolation ability.
1. Floor element. Begin with the floor element. For integration into the kitchen,
install the adjustable feet to the floor element, and adjust to the desired height in
relation to plinth height of the kitchen. Check that the floor element is stable and
level. The maximum plinth height is190mm and the minimum is 145mm. Freestand-
ing corner fridges do not need adjustable feet. The floor element must be stable
and level. This is essential to ensure the other elements and door will achieve a
good seal.
2. Side walls. Before installing the side walls, check that the lock tabs engage the
lock housing. Twist the lock tabs back all the way until you hear a click. For cor-
rect locking, turn the Allen key approx. 145°. NOTE: The elements can creak when
being locked. Mount the side walls on the floor element and lock them together.
Fit the top element and lock into place. Fit the white plastic plugs supplied over
the lock holes to conceal them. NOTE: Power supply cable in back wall of ceiling
element must be accessible and hang down freely for connection of back wall.
There are mounted ledge lists for the door on all items. Check that the four fittings
are flush in the corners.
3. Roof element. It is important that there is minimum free space of 100mm from
top of the roof element to the ceiling due to disassembly if necessary. If fitting
full-cover stainless steel elements, then now go straight to "Installing full-cover
stainless steel elements for freestanding corner fridges."
4. Back wall with refrigeration unit. The
mechanical element of the cooling wall must
face in towards the corner in the kitchen.
Before lifting the back wall through the door
opening in the fridge, use protective mate-
rial in the bottom floor to avoid scratches.
( Floor protection sheet in white plastic
material is also available as extra part num-
ber 9947551200) Assembly the backwall in
the niche by lifting the backwall through the
dooropening, tilt the top against you and lift
the backwall into the niche. Grasp the cord
from the ceiling element and connect this
cord to the back wall, labelled "light". Check
that the power cable could be reached after