Table of Contents
Advertisement
Available languages
Available languages
SAFETY AND ENVIRONMENTAL INSTRUCTIONS
•
Use the device in dry indoor environments only.
•
Protect the device from humidity.
•
Do not open the device. RISK OF ELECTRONIC SHOCK! Refer opening and servicing to
qualified personnel.
•
Connect this device to a properly installed and earthed wall outlet only. Make sure the mains
voltage corresponds with the specifications on the rating plate.
•
Make sure the mains cables stay dry during operation. Do not pinch or damage the mains
cable in any way.
•
A damaged mains cable or plug must immediately be placed by an authorized service center.
•
In case of lighting, immediately disconnect the device from the mains supply.
•
Children should be supervised by parents when using the device.
•
Clean the device with a dry cloth only.
•
Do not use cleaning agents or abrasive cloths!
•
Do not expose the device to direct sunlight or other heat sources.
•
Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
•
Do not cover the ventilation openings!
•
Install the device at a safe and vibration-free location.
•
Install the device as far away as possible from computers and microwave units; otherwise
radio reception may be disturbed.
•
Do not open or repair the enclosure. It is not safe to do so and will void your warranty.
Repairs only by authorized service/ customer center.
•
The device is equipped with a "CLASS 1 LASER". Avoid exposure to the laser beam as this
could cause eye injuries.
•
Only use mercury and cadmium-free batteries.
•
Used batteries are hazardous waste and not to be disposed of with the household waste!!!
Return the batteries to your dealer or to collection points in your community.
•
Keep batteries away from children away from Children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.
•
Check your batteries regularly to avoid battery leakage.
UNPACKING AND SET UP
•
Carefully remove the unit from the display carton and remove all packing material from the unit.
•
Unwind the AC power cord and extend it to its full length.
•
Unwind the FM Antenna wire and extend it to its full length.
•
Place the unit on a stable, level surface convenient to an AC outlet.
•
Connect the plug to your AC 230V,50Hz outlet.
POWER SOURCE
This system is designed to operate on normal 230V 50Hz only. Attempting to operate from any
other power source may cause damage to the system, and such is not covered by the warranty.
Note: If this plug will not fit into your outlet, you probably have an outdated non-polarized AC
outlet. You should have your outlet changed by a qualified licensed electrician.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from moving when
you operate the controls. These ‚feet' are made from non migrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However certain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber ‚feet'
to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your
furniture we strongly recommend that you purchase small self-adhesive felt pads, available
at hardware stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber ‚feet' before you place the product fine wooden furniture.
EN - 23
EN
Advertisement
Table of Contents
