Table of Contents
Advertisement
Waveform Menu
State-Per-Clock
Mode
Analyzing the Intel 80386DX/DXL
2-22
Captured data is displayed in the Waveform menu as shown below.
Figure 2-15. Waveforms Display
State-Per-Clock mode clocks the logic analyzer on every K clock rising
and falling edge regardless of whether or not valid transfers occur;
therefore, every state which crosses the target system microprocessor's
bus is captured. This allows the logic analyzer to capture wait states
and idle states, in addition to valid address states and data states.
To select State-Per-Clock mode, install the jumper on J2, and change
the Clock field to K . Note that inverse assembly is not supported in
State-Per-Clock mode.
80386DX/DXL Preprocessor Interface
HP E2444A
Advertisement
Table of Contents
