Restrict To Real-Time Runs; Emulator Reconfiguration - HP 7700 Series User Manual

Restrict to real-time
runs?
Caution
Emulator
Reconfiguration
The "restrict to real-time" question lets you configure the emulator so
that commands which cause the emulator to break to monitor and
return to the user program are refused.
no All commands, regardless of whether or not they
require a break to the emulation monitor, are
accepted by the emulator.
yes When runs are restricted to real-time and the
emulator is running the user program, all
commands that cause a break (except "reset",
"break", "run", and "step") are refused. For
example, the following commands are not allowed
when runs are restricted to real-time:
Display/modify registers.
Display/modify internal RAM or SFR.
Display/modify target system memory.
Load/store target system memory
If your target system circuitry is dependent on constant execution of
program code, you should restrict the emulator to real-time runs. This
will help insure that target system damage does not occur. However,
remember that you can still execute the "reset", "break", and "step"
commands; you should use caution in executing these commands.
The emulator reconfiguration questions allows you to reconfigure the
emulator for your system. Type of the processor, processor operation
mode and reset value for the stack pointer will be configured here. To
access the emulator reconfiguration questions, you must answer "yes"
to the following question.
Reconfigure emulator?
Configuring the Emulator 4-5