IBM ServeRAID-4 Ultra160 Series User Reference page 100

Scsi controller
Hide thumbs Also See for ServeRAID-4 Ultra160 Series:
Table of Contents

Advertisement

When using:
Windows NT 4.0
Windows 98
Windows 95
NetWare
Linux
OS/2
OpenServer
UnixWare
Installing ServeRAID Manager on Windows 2000, Windows NT 4.0,
Windows 98, or Windows 95
Notes:
1. This version of the ServeRAID Manager program supports up to 12 ServeRAID
2. On Windows 95 and Windows 98 the ServeRAID Manager program works only
To install the ServeRAID Manager program for Windows NT 4.0, Windows 2000,
Windows 98, or Windows 95, do the following:
1. Insert the IBM ServeRAID Support CD into the CD-ROM drive.
2. The installation program starts. Follow the instructions on the screen to install
Installing ServeRAID Manager on NetWare
Notes:
1. To install the NetWare version of the ServeRAID Manager program, you must
2. ServeRAID does not support NetWare versions older than 4.x.
3. ServeRAID Manager supports only NetWare 5.x and later. Use the command
4. The NetWare version of the ServeRAID Manager program supports up to 8
82
®
IBM
User's Reference: ServeRAID
Go to:
"Installing ServeRAID Manager on Windows 2000, Windows NT 4.0,
Windows 98, or Windows 95".
"Installing ServeRAID Manager on Windows 2000, Windows NT 4.0,
Windows 98, or Windows 95".
"Installing ServeRAID Manager on Windows 2000, Windows NT 4.0,
Windows 98, or Windows 95".
"Installing ServeRAID Manager on NetWare".
"Installing ServeRAID Manager on Red Hat Linux 6.2 (or later)" on
page 83.
"Installing ServeRAID Manager on OS/2" on page 84.
"Installing ServeRAID Manager on OpenServer" on page 84.
"Installing ServeRAID Manager on UnixWare" on page 85.
controllers when using Microsoft NT 4.0 or Windows 2000.
as a console. You must use the console to connect to remote servers that
contain ServeRAID controllers. Servers installed with Windows 95 and Windows
98 do not support ServeRAID controllers.
the program.
Note: If you are installing on an IBM server that supports Active PCI under
Windows NT 4.0, select the IBM ServeRAID Hot Replace Wizard to
enable the hot-replace operation.
install it from a Microsoft Windows client that is connected to the NetWare
system.
line utilities IPSSEND and IPSMON for NetWare 4.x.
ServeRAID controllers.
-4 Ultra160 SCSI Controller

Advertisement

Table of Contents
loading

Table of Contents