Table of Contents
Advertisement
4—Nexus Camera Configuration
4.2
Basic Web Configuration
To make configuration changes with software, use a web browser to
connect with the camera. If the IP address of the camera is known,
you can type the IP address into the browser. As shipped from the
factory, the camera has an IP address of 192.168.250.116 with a
netmask of 255.255.255.0.
The Web Configuration Tool will start at the Login screen, which
shows an image of the camera. When this screen appears, the PC is
successfully connected to the camera over the IP network.
Select
Login (there is no password for the Basic user). Initially, the Help page
will be displayed. This page has information about the camera including
hardware and software revision numbers, part numbers, and serial
numbers. If you need to contact FLIR for support, this information will be
useful to the support engineer. On the left side of the page is a list of
hyperlinks to the web pages that are used to configure the Nexus
camera.
For most installations, the "basic" login provides access to the
parameters that will typically be changed. For more advanced
configurations, it is also possible to login as "admin", and that login
provides access to a greater number of configuration parameters. The
"admin" login requires a password (initially "indigo") and this password
can be changed for security purposes.
The remainder of this guide describes the configuration parameters that
are available to the basic user. The sections are organized in the same
order as the links on the left.
4.3
Settings
In most cases the Settings page is not used. If necessary, the Log max size can be set to a
non-zero number to allow log messages to be displayed. See "Log File" on page 4-16.
4-2
Login as Basic
User, or type "basic" as the User and click on
January 2012
Nexus Configuration Guide
427-0030-00-28, version 100
Advertisement
Table of Contents
