Table of Contents
Advertisement
2—Verify Camera Operation with FSM
No Sensors Discovered
Control Panel
Select camera name
Step 4
Select the Video Wall 0 tab and confirm that video is streamed to the monitor.
Step 5
Confirm it is possible to control the camera using buttons in the Control Panel. For
example, click on the zoom in button (magnifying glass with +), and the video will zoom
to 2X. For a pan/tilt camera, use the up/down and pan left/right controls to move
the camera.
Once you have verified the basic operation of the camera and successfully streamed video, you
may want to make some configuration changes. For example, the camera can be configured
with an IP address that matches the installation network. Refer to Chapter 4.1 "IP
Communications" on page 4-1for a brief guide on how to configure the camera.
When you are ready to install the camera in its final location, confirm the cables are properly
attached and the DIP switches are set as desired. Reassemble the rear cover after confirming
the ground wire is connected properly, and tighten the cable gland nuts to ensure a good seal
all around.
2-4
Setup
Refresh
Move to Active Servers list
January 2012
Nexus Configuration Guide
Discovery
427-0030-00-28, version 100
Advertisement
Table of Contents
