System Information Displayed At Startup; Flir Certified Systems Integrator (Fcsi) Training - FLIR Nexus Configuration Manual

1—Nexus IP Camera Configuration
If you are using the IP interface to configure the serial communication settings for the camera,
refer to section 4.6 "Serial Remote" on page 4-6.
The DIP switches are only used to control serial communications parameters. Other settings,
related to IP camera functions etc., must be modified via software (using a web browser).
1.7

System Information Displayed at Startup

When the camera is turned on, the video temporarily displays system information including the
serial number, IP address, Pelco address, Baud rate, and setting of the serial control DIP
switch: SW - software control (the default) or HW - hardware.
S/N: 1234567
IP Addr: 192.168.250.116
PelcoD (Addr:1): 9600 SW
1.8

FLIR Certified Systems Integrator (FCSI) Training

This configuration guide provides a brief description of the configuration parameters that are
available through the basic user login. For installers and integrators that are interested in a
more advanced level of configuration, the FLIR Certified Systems Integrator (FCSI) certification
program offers hands-on training with a variety of FLIR cameras, and focuses on integration
design and installation with other third-party security sensors and equipment. For more
information, contact your local FLIR representative or visit one of the following web sites:
http://support.flir.com/
http://www.flir.com/training
1-4 January 2012
Nexus Configuration Guide
427-0030-00-28, version 100