Clearing An Alarm; Paused Readings - LogTag Recorders TREL30-16 Product User Manual

During Recording

Clearing an Alarm

During configuration with LogTag
display. This is a useful function for an inspector, so repeated alarms can be recognized
easier.
This display screen shows an existing
alarm that occurred yesterday, but has
not yet been cleared.
To clear an alarm, press and hold the
button.
REVIEW
/MARK
After approx. 2 seconds the cross
will be replaced with the tick
Release the button when the tick
appears. The normal recording display
is shown.
The alarm will not be cleared if you:
Release the button before the
l
Keep holding the button after the
l
than 2 seconds
In this example the paused function
was activated, and the paused symbol
is shown on the display. For more
information about paused readings
please see the section about
Readings below.
Note: Only the Alarm Indicator ( ) can be cleared! The day alarm marker (
above example) remains shown, as it is part of the statistic summary. Clearing an
alarm also does not reset any of the delay values. Please see
for additional information.

Paused Readings

During configuration of the TREL30-16 you can set the option to ignore up to 15 readings
for alarm and statistics calculations after either button is pressed. The readings are still
shown on the graph and in the data listing, but they are labelled as paused, and their
TREL30-16 User Guide
®
Analyzer you can allow users to clear an alarm on the
.
symbol remains permanently on
symbol remains permanently on for more
Paused
in the
Alarm Configuration
25