Advanced Configuration Settings - LogTag Recorders TREL30-16 Product User Manual

Standard Configuration Options
previous day is shown (
previous day. When midnight passes next, this marker will move to
Alarm Re-triggering
A note on alarm re-triggering:
delay time (but not any others) resets to zero and alarm processing starts again.
The alarm processing for all other alarm delays is not affected. Therefore,
accumulative or consecutive alarms will re-trigger, if the alarm conditions are met
again, and the Alarm Indicator ( ) and the Day Alarm Marker (
even if any previous alarm was cleared. Clearing an Alarm does not reset any of
the delay values.

Advanced Configuration Settings

Select Advanced Settings for additional configuration settings. These settings decide how
some of the elements are displayed on the unit's own display and set certain options
specific to the TREL30-16.
Figure 2: TREL30-16 advanced configuration screen in LogTag
Parameters that influence the appearance of the display are:
Pause alarm/statistics processing (see
l
Temperature display unit (see
l
Switch off display after 30 seconds (Power save, see
l
showing the number of days on the display, for which statistics were collected (see
l
Total Number of Days Statistics Collected on
allowing a user to reset the trip's minimum and maximum values on the display
l
during recording
page 33)
Parameters influencing specific behavior of the TREL30-16 are:
clearing and resetting alarms when the
l
Clearing an Alarm on page 25)
TREL30-16 User Guide
) to indicate the alarm was registered against what is now the
As soon as an alarm is triggered, the corresponding
Display Overview on
(see Resetting the Trip Minimum/Maximum Temperatures on
®
Analyzer 3
Paused Readings on
page 16)
Power Save on
page 28)
button is pressed
START
/CLEAR/STOP
and so on.
) will be shown,
page 25)
page 27)
(see
14