Jung 3181-1 Series Operating Instructions Manual

Jung 3181-1 Series Operating Instructions Manual

Standard / universal automatic switch 1.1 m

Advertisement

Quick Links

Standard / Universal automatic switch 1.1 m
Universal automatic switch 1.1 m
Art. no.: ..3181-1..
Standard automatic switch 1.1 m
Art. no.: ..3181..
Operating instructions
1
Safety instructions
Electrical devices may only be mounted and connected by electrically skilled persons.
Serious injuries, fire or property damage possible. Please read and follow manual fully.
Do not press on the sensor window. Device can be damaged.
The device is not suitable for use as a burglar alarm or other alarm.
Caution. Damage to sensors may result due to high thermal radiation. Avoid direct sunlight pen-
etration in the sensor window.
These instructions are an integral part of the product, and must remain with the end customer.
2
Battery safety instructions
This device or its accessories are supplied with batteries in the form of button cells.
DANGER! Batteries can be swallowed. This can lead directly to death by suffocation. Danger-
ous substances may cause severe internal burns leading to death within 2 hours.
Keep new and used batteries away from children.
Do not use devices if the battery compartment does not close securely and keep away from
children.
If you suspect that a battery has been swallowed or is in any orifice of the body, seek immediate
medical attention.
WARNING! Improper handling of batteries can result in explosion, fire or chemical burn due to
leakage.
Do not heat or throw batteries into fire.
Do not reverse polarity, short-circuit or recharge batteries.
Do not deform or disassemble batteries.
Replace batteries only with an identical or equivalent type.
Remove empty batteries immediately and dispose of in an environmentally friendly manner.
32597033
j0082597033
1 / 13
24.07.2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3181-1 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Jung 3181-1 Series

  • Page 1 Standard / Universal automatic switch 1.1 m Universal automatic switch 1.1 m Art. no.: ..3181-1.. Standard automatic switch 1.1 m Art. no.: ..3181.. Operating instructions Safety instructions Electrical devices may only be mounted and connected by electrically skilled persons. Serious injuries, fire or property damage possible. Please read and follow manual fully. Do not press on the sensor window.
  • Page 2: Device Components

    Standard / Universal automatic switch 1.1 m Device components Figure 1: Device components Figure 2: Adjuster Bus coupler 3 (accessory) Frame Motion detector Sensor window Slide switch (cover) Adjuster Sens. Slide switch element Programming button Function System information This device is a product of the KNX system and complies with the KNX directives. Detailed tech- nical knowledge obtained in KNX training courses is a prerequisite to proper understanding.
  • Page 3 Standard / Universal automatic switch 1.1 m Recommendation: Use air-tight appliance boxes. Product characteristics – Automatic switching of light, depending on heat motion and ambient brightness – 2 PIR sensors – Detection field 180° – Integrated brightness sensor – Adjustable switch-off brightness –...
  • Page 4 Standard / Universal automatic switch 1.1 m – Temperature of the heat source: surfaces at 37 °C radiate more intensely than at 10 °C(Figure 5). – Contrast between the heat source and the environment: if the heat source radiates just as intensely as the environment.
  • Page 5: Operation

    Standard / Universal automatic switch 1.1 m Figure 6: Heat sources in buildings Some of the mentioned effects can be compensated for using intelligent filter switches by calib- rating the received signals with typical motion patterns. Selecting the device and installation loc- ation should be made so that the detection field is suited for the intended purpose.
  • Page 6: Ir Remote Control

    Standard / Universal automatic switch 1.1 m Switching the light on manually ■ Move the slide switch to the ON position. Switching the light off manually ■ Move the slide switch to the OFF position. Switching on the Automatic operating mode ■...
  • Page 7 Standard / Universal automatic switch 1.1 m Button Function Ì Function block 1: Brightness threshold 150 lx Í Function block 1: Brightness independent op- eration É Function block 1: Set current brightness as brightness threshold 10 SEK, 30 SEK, 2 MIN, 5 MIN, 30 MIN Function block 1: Extend minimum run-on-time (10 seconds) by the selected value START, STOP...
  • Page 8: Fitting And Electrical Connection

    Standard / Universal automatic switch 1.1 m Information for electrically skilled persons DANGER! Mortal danger of electric shock. Cover up live parts in the installation environment. 7.1 Fitting and electrical connection Detection field and range Figure 9: Range with tangential direction of motion Figure 10: Range with radial direction of motion The size of the detection field depends on the direction of motion and the adjusted sensitivity.
  • Page 9 Standard / Universal automatic switch 1.1 m Figure 11: Detection field and mounting height Selecting installation location ■ Select a vibration-free installation location. Vibrations can lead to unwanted switching. ■ To achieve optimum range, choose an installation location that is transversal to the direc- tion of motion.
  • Page 10 Standard / Universal automatic switch 1.1 m Figure 14: Range with radial direction of motion Mounting the panel Figure 15: Dismounting of slide switch Figure 16: Dismounting of design cover Figure 17: Mounting, cover, ranges LS/CD and A ranges Ranges LS, CD: 32597033 24.07.2019 10 / 13 j0082597033...
  • Page 11 Standard / Universal automatic switch 1.1 m ■ Remove the cover from the slide switch (5) (Figure 15). ■ Use a screwdriver to carefully remove the design cover (Figure 16). ■ Mount the cover for the left or right side of the device (3) (Figure 17). Series A: ■...
  • Page 12: Disposal Of Batteries

    Standard / Universal automatic switch 1.1 m Locking the slide switch Figure 18 The slide switch can be mechanically locked to the AUTO position as required. Use the provided locking screw for this. ■ Remove the cover from the slide switch (5) (Figure 15). ■...
  • Page 13: Warranty

    Art. no. 2073U IR remote control Art. no. KNX PM FB IR 11 Warranty The warranty is provided in accordance with statutory requirements via the specialist trade. ALBRECHT JUNG GMBH & CO. KG Volmestraße 1 58579 Schalksmühle GERMANY Telefon: +49 2355 806-0 Telefax: +49 2355 806-204 kundencenter@jung.de...

This manual is also suitable for:

3181 series

Table of Contents