Yealink T58A Manual page 18

Auto Provisioning Guide for Yealink
Item
overwrite_mode
specific_model.excluded_
mode
14
Teams IP
Phones
For example, sip.cfg, HTTP Directory/sip.cfg
Absolute URL:

For example, http://10.2.5.258/HTTP Directory/sip.cfg
The URL must point to a specific CFG file. The CFG files are
downloaded in the order listed (top to bottom). The parameters
in the new downloaded configuration files will override the
duplicate parameters in files downloaded earlier.
The "include" statement can be repeated as many times as
3)
needed.
The [$MODEL] can be added to specify settings for specific
4)
phone models. $MODEL represents the phone model name. The
valid phone model names are: T58A, T56A, T55A, VP59 and
CP960. Multiple phone models are separated by commas. For
example, [T58A, CP960]
Enable or disable the overwrite mode. The overwrite mode is applied
to the configuration files specified to download. Note that it only
affects the parameters pre-provisioned via central provisioning.
1-(Enabled) - If the value of a parameter in configuration files is left
blank, or if a non-static parameter in configuration files is deleted or
commented out, the factory default value takes effect.
0-(Disabled) - If the value of a parameter in configuration files is left
blank, deleted or commented out, the pre-configured value is kept.
Note: This parameter can only be used in boot files. If a boot file is
used but the value of the parameter "overwrite_mode" is not
configured, the overwrite mode is enabled by default.
Enable or disable the exclude mode. The exclude mode applies to the
configuration files specified in the boot file.
0-Disabled (Append Mode), the phone downloads its own model-
specific configuration files, and downloads other model-unspecified
configuration files.
1-Enabled (Exclude Mode), the phone attempts to download its own
model-specific configuration files; if there is no own model-specific
configuration files found on the server, it downloads model-
unspecified configuration files.
Note: Exclude mode can only be used in boot files. If a boot file is
used but the value of the parameter "specific_model.excluded_mode"
is not configured, the exclude mode is disabled by default.
Guidelines