Volkswagen Passat 2011 Workshop Manual page 61

– Unscrew bolts -B-.
– Detach control motor -A- from mounting -D-.
– Detach pin -E- of control motor from mounting of cam plate
-F-.
– Mark connector -C- (to prevent interchanging if several con‐
nectors are separated at the same time) and remove.
– Remove control motor -A-.
Installing
– Observe notes ⇒ page 6
Note
♦ Risk of malfunction of heater or air conditioning system caused
by improperly installed control motors or links.
Mark the correct allocation of the connectors to the control
♦
motors.
Always install the appropriate links to the control motors.
♦
Install in reverse order of removal, observing the following.
– Check proper operation and function of air recirculation flap
-C- and air flow flap -B- by turning cam plate -A-. While doing
this, make sure that pins on levers are properly seated in
grooves in cam plate -A-.
– Position cam plate -A- so that link of control motor can be in‐
serted.
Note
On vehicles without air flow flap control motor - V71- , the air re‐
circulation flap and air flow flap of the air recirculation flap control
motor - V113- are set via a cam plate. To ensure the shortest time
possible until the air recirculation mode is attained, the cam plate
is designed in such a way that the air recirculation flap is open
and the air flow flap is closed at both limit stops of the control
motor. In fresh air mode (air recirculation flap closed and air flow
flap opened) the air recirculation flap control motor - V113- is ap‐
proximately in centre position.
.
Passat 2011 ➤ , Passat Variant 2011 ➤
Heating, air conditioner - Edition 06.2017
57
4. Control motors