Factory) Configuration Of The Ld4Nx St Card With Stocko Format - Aastra X series Installation And Implementation Manual

4.5 (Factory) configuration of the LD4NX ST card with Stocko
format
J1
Two operating modes can be configured on the LD4NX ST card:
• LD4N operating mode: LD4N default configuration (operating mode compatible with the old
LD4).
• The LD4X operating mode, compatible only with software release 4.1 and later: The LD4X
operating mode is obtained by removing or adding jumper J14 of the LD4NX ST card in slot
1-2, and offers the following additional features:
• Since the LD4NX ST in LD4X mode uses the dedicated trunk of its slot, there are no
longer any restrictions on the location of the card.
• The card's hardware information can be read through the MMC (presence of an
EEPROM on the LD4NX ST card in LD4X mode).
• It is possible to declare up to10 LD4NX ST cards in LD4X mode of a NeXspan L.
• It is possible to read the status of the S0 access of the LD4NX ST card in LD4X mode
remotely once the card is in service.
Page 4-85
J14
1 2 3
J14
J11
Figure 4-7: Top view of the LD4NX ST card
10/2008
J2
SW5 SW6
J4
2 1
J1-1 J2-1
J6
J1-2 J2-2
CA1 HVAL
J5
J1-3 J2-3
1 6
J3
J1-4 J2-4
5 10
CA1 HVAL
ON
1 2
CA1.1 = ON HVAL
CA1.1 = OFF H not validated
CA1.2 = not wired
4
J7
1
4
J8
1
RUN
DISA
4
J9
1
4
J10
1
AMT/PTD/TR/0020/2/7/EN