Configuring A Mobile Terminal M910/M915 - Aastra X series Installation And Implementation Manual

2.4.2 Configuring a mobile terminal M910/M915

Registering a mobile terminal M910/M915
It is important to follow the procedure below when registering the M910 for the first time.
1 On the mobile terminal, the line "Register" is displayed. Press the Menu key, select System
using the
2
Select Register using
3 The line "PARK ? :" appears. Do not make any entry. Press Next.
4 The line "BS-PIN" appears. Enter the mobile terminal number (4 digits) and confirm with OK.
5
The line "Name" appears. Enter the name of the PBX on which the mobile terminal has just
been registered and press OK to confirm.
6
The line " Int No." appears. This is a user information line. The number of the mobile can be
entered here, for example, or the number to be called if the mobile is lost. Enter the
information and confirm with OK.
7
The mobile terminal must be configured on the previously registered base station. Select
"Menu, System, Select base station (choose the base station corresponding to the name
entered in 5)"
Note: After registering the mobile terminal, to change the PBX name and/or the Int No., use the
selection "Menu, Device, OK, Save, OK, Opt, Edit; enter PBX name, OK; enter Int No.,
OK".
Cancelling a registration
When the mobile terminal is registered on several base stations, to cancel the registration on a
non-selected base station, proceed as follows:
1 Press the Menu key, select System using the
2
Select Register using
3
Select the base station to be deleted using the
4 Press the Opt key, select Delete using the
If the mobile is registered with a single base station, refer to the Installer menu.
Call rejection function
There are two options when an incoming call is received.
• The sil (silence) function removes the ring tone without interrupting the call.
• The rej (reject) function allows the calling party to suddenly hang up. When the function is
activated, a "Wait" message is displayed for 35 seconds. The mobile terminal can no longer
receive or make calls within these 35 seconds (busy tone). To seize the line after rejecting a
call, just activate the "PLD" (line seizure) key.
AMT/PTD/TR/0020/2/7/EN
keys and confirm with OK.
and confirm with OK.
and confirm with OK.
10/2008
keys and confirm with OK.
keys.
keys and confirm with OK.
Page 2-44